Parameters And Specifications; Audio Out; Mounting The Dvd In A Car - LENCO MES-405 User Manual

Table of Contents

Advertisement

Available languages

Available languages

6. Parameters and specifications

Electronical parameters
Power requirements
: AC 100-240V, 50/60 Hz
Power consumption
: <15W
Operating humidity
: 5% to 90%
VIDEO OUT
: 1 Vp-p (75Ω)

AUDIO OUT

: 1.0 Vrms (1 KHz, 0dB)
Audio
: Speaker: 1WX2, Headphones output
System
Laser
: Semiconductor laser, wavelength 650 nm
Signal system
: NTSC/PAL
Frequency response
: 20 Hz to 20 kHz (1dB)
Signal-to-noise ratio
: More than 80 dB (ANALOG OUT connectors only)
Dynamic range
: More than 80 dB (DVD/CD)
Note: Design and specifications are subject to change prior notice.

Mounting the DVD in a Car

Use the supplied mounting kit to install the DVD players on the back of the vehicle's
headrests.
1.
Align the angled support's bolt to the screw hole
on the back of the DVD unit. Turn the bolt
clockwise and secure the support.
2.
Lift the headrest off its leg supports. Align the
horizontal support with the headrest leg slots
and ensure the horizontal support rests
securely on the top of the car seat. Reattach
the headrest.
Remark: If the legs of the headrest are too
thick for the opening of the horizontal support
bar of the bracket, please unscrew the 4
screws of the support bar of the bracket to
adjust the opening. In case the screws are too
short, use the longer screws (provided in the
giftbox).
3.
Grip the DVD firmly with both hands and slot the
angled support firmly into the support bar. It will
click. Ensure the entire unit is secure.
4.
Adjust the angle of the DVD unit, then secure by
tightening the bolt on the right.
5.
To remove the DVD from the horizontal support bar,
support the DVD unit with one hand. With the other
hand, firmly squeeze the release buttons ^ either
side of the angled support and pull.
Support
This unit should never be used by the vehicle's driver or left unsecured in the vehicle
while driving.
If this unit is being used in your vehicle. be sure that it is secured or held safely, and
does m obstruct any safety device, including air bags or seat belts.
Al passengers should wear seat belts when using this unit In a moving vehicle.
If In doubt, please contact your vehicle manufacturer for further advice.
11
Headrest
Leg support
Horizontal support
bar

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents