Band Select; Manual Tuning/Automatic Tuning; Storing And Recalling Stations; Mono/Stereo Reception - Hyundai H-CCR8100 Instruction Manual

Operation
Manual/automatical tuning
• Press and hold
to display MANUAL. Now you can
press these buttons repeatedly to
adjust the needed frequency manually.
• To adjust the needed frequency
automatically, press
The radio will seek to the next down or
up strong and clear frequency station.
Repeat this action to seek for other
desired stations.

Storing and recalling stations

To store a station
To store a station, select the desired
band and station. Press and hold the
desired number button for more than
2 seconds. When stored, the preset
number will appear on the display.
The station can be recalled anytime
by pressing the corresponding number
button.
Store stations automatically
• Press and hold F/PS button on
the panel or APS button on the RC for
more than 2 seconds to automatically
find and store 6 strongest stations in
the current band.
• After the 6 strongest stations are
saved, press F/PS button on the panel
or APS button on the RC; scanning of
all stored station will begin.
Mono/Stereo control
radio mode)
Press SELECT button on the panel
or SEL button on the RC repeatedly
until the display shows STEREO
(MONO). Turn VOLUME knob or
press VOL+/VOL- buttons on the RC
to switch between stereo reception
or mono reception. Improvement of
reception of distant stations can be
12
done by selecting mono mode, which
may cut down some reception noise.
/ buttons
availability varies with areas. Please
/ buttons. understand if RDS service is not
available in you area, the following
service is not available, either.
function
the AF function on or off.
poor, enabling the AF function will
allow the unit to automatically search
another station with the same PI
(Program Identification) as the current
station but with a stronger signal,
so that you do not have to retune
the stations when driving between
different transmitter coverage areas.
When AF symbol is on, it means
RDS information is received; when
AF symbol is flashing, it means RDS
information is not yet received.
name of station will be display instead
of frequency.
in your area, turn off the AF mode.
Default setting is ON.
(in FM
on or off.
be automatically searched, until the
program is received. When traffic
announcement is received the unit will
temporarily switch to the tuner mode

RDS function

RDS (Radio Data System) service
AF (Alternative Frequencies)
Press and hold SEL button to turn
When the radio signal strength is
PS (Program Service name): the
If RDS service is not available
TA (Traffic Alarm) function
Press TA button to turn TA function
In TA mode traffic program will