Uniden BC785D Owner's Manual page 79

6. Press SCAN on both scanners.
The data transfer begins from the Master Unit to the Slave
Unit.
During the data transfer, both scanners show the following
displays.
When the data transfer is complete, COMPLETE displays.
If the data transfer is not successful, the following error
message will appear.
Note: • To clear ERROR, press
To exit the Clone mode, press MENU repeatedly.
Note • Once you have completed the cloning of the scanners, reset the scanners by
turning the scanners OFF and then ON again. This is particularly important to know
if you wish to clone another scanner right away.
Remember! You can also use L or M instead of rotating the VFO.
Also instead of pressing E, you can press the VFO control.
(decimal key).
.
75