Endon Monaco Instruction Manual

Safety Warnings

• This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring
Regulations. It is for indoor use only, and not suitable for a Bathroom location.
• This fitting is a Class I product, and must be connected to Earth.
• Do not plug into the mains until your lamp is fully assembled.
• Under no circumstances must this table lamp be covered with any material as this could pose a safety
hazard. It must be used on a stable, flat surface.
• This product is not suitable for persons under 14 years of age.
• Never fit bulbs of a higher wattage than those specified on the label, as these may cause overheating and
damage the fitting.
• The lamp must be protected by a 3 amp fuse in the mains plug.
• If the mains cable becomes damaged it must only be replaced by a technically competent, qualified person.
• If you are in any doubt about your competence please consult a qualified electrician.
• This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.
• If any modification is made it will invalidate the warranty and may render the product unsafe.
• Allow 10 minutes to cool before replacing, adjusting or cleaning.
• Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Assembly/ User Instructions

Please read these instructions carefully before fitting and retain for reference. Check the packaging and make
sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
1. Carefully unpack your lamp, and place on a stable, flat surface.
2. Screw the stem (1) onto the controls section. Screw loose stem (2) onto controls section. Slide the plate with
2 holes onto the bottom of the stems, pulling the cable through the base.
3. Slide the washer and nut (3) along the cable and tighten lightly. Screw the loose nut and washer onto the
other stem. Ensure the 2 stems are parallel and fully tighten the nuts.
4. Pull cable through the cable clamp in the side of the base (4) and lock it with the plastic screw (5).
5. Install the Bulbs, avoiding touching them with bare hands - use a cloth or gloves.
6. Fit the glass (6 & 9) and secure it by fitting and tightening the 3 small metal strips with the 3 self tapping
screws (7 & 10).
7. Finally fit the adjustment handle (11) by screwing it onto the child lamp head. NOTE: Only the tip of this rod
is intended to be used to adjust the fitting.
8. Plug in, and operate the switch to turn your Lamp on.
If your Lamp will not illuminate, please check the bulb, the 3 amp fuse in the plug and ultimately check the
relevant fuse in your Fuse Box. If unsuccessful please consult your Retailer.
Endon Lighting, LS9 0SE
Monaco Floor Light
INSTRUCTION MANUAL

Before you start

Green & Yellow
(Earth)
E
N
Blue
(Neutral)

Class I Plug Wiring Diagram

Fuse
(3 AMP)
L
Brown
(Live)
MONACO-Monaco-FL 20161006