Hoover ONEPWR FLOORMATE JET User Manual page 16

TROUBLESHOOTING (CONT.)
Issue Possible Cause
Machine won't turn on 1. Battery not installed properly
2. Battery does not have a charge
3. Handle is not fully installed
4. An obstruction prevented brush roll from spinning
1. Cap on solution tank is not closed tightly
Leaking
2. Solution tank is not installed properly
Floors are streaked 1. Too much solution was applied
2. Solution other than recommended Hoover Multi-surface solution was used
3. Solution was not mixed properly
4. Brush roll was not rinsed and dried fully after prior use
Light on the charger is flashing red, and 1. There is an error with the battery
battery won't charge
16
Suggested Solution
1. Remove battery, align guide rails to the front of the battery compartment and slide battery down until it clicks to ensure proper connection
2. Recharge battery, White lights will blinki when battery is charging. Once completely charged, all lights will be off. All four white lights
will illuminate when battery charge button is pressed and battery is fully charged.
3. Remove battery, ensure handle is installed properly per assembly instructions on page 7
4. Turn power OFF and remove battery, follow instructions for care of brush roll and cover on page 12. Ensure brush roll is free of hair and
debris and reinstall. If problem persists, wait 30 minutes and try again
1. Turn power OFF, remove solution tank, tighten cap and reinstall
2. Turn power OFF, remove solution tank and reinstall until snug
1. Clean area in HIGH mode without engaging the trigger to remove excess solution
2. Clean the area using the recommended Hoover Multi-surface line of solutions and follow the instructions for filling the tank on page 8
3. Follow the instructions for filling the tank on page 8 and reclean the area
4. Follow the instructions for rinsing the brush roll on page 12 and reclean the floors
1. Remove battery from charger and try again. If problem persists, call customer service for support