Table of Contents
Related Manuals for HELLER DAYNE
Summary of Contents for HELLER DAYNE
- Page 1 CEILING FAN INSTALLATION MANUAL Models: DAYNE & EBONY Fan picture is for illustration purposes only. Styles will vary according to the particular models. READ AND SAVE THESE INSTRUCTIONS MUST BE INSTALLED BY A LICENSED ELECTRICIAN...
- Page 3 The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Page 4 PREPARATION: ‡ Unpack your ceiling fan carefully, then remove all parts and components, and lay on a cloth or soft surface to avoid damage. DO NOT lay the motor housing on its side, the housing may get damaged. Before commencing installation, check that all parts are included. NB: You may need to remove ‡...
-
Page 5: Selecting A Location
SELECTING A LOCATION: Choose a location for mounting the fan where the blades will have at least 2.1 metres of clearance from the floor. Make sure that the installation site will not allow the rotating fan blades to come into contact with any object and that there is a minimum clearance of 150mm (6”) from the blade tip to the wall or ceiling. -
Page 6: Installation
INSTALLATION: CAUTION: Before installing the fan, make sure you have turned OFF the electricity supply. Secure the hanging bracket to the ceiling joist or suitable structure that is capable of carrying a load of at least 45Kg, with the two long fixing screws provided. Ensure that at least 30mm of the screw is threaded into the support. -
Page 7: Electrical Connections
ELECTRICAL CONNECTIONS: For your convenience, and to assist in easy installation & cleaning, your ceiling fan is connected with Mawson’s easy connect system. Simply connec t the male and female couplings, and then ensure all excess wiring is retained inside the ceiling canopy. The appliance must have a means for disconnection from the supply mains having a contact separation in all poles that provide disconnection under overvoltage category III conditions. -
Page 8: Reverse Switch
REVERSE SWITCH: The “Summer / Winter” switch should be in the forward position to make the fan rotate in an anti- clockwise direction during summer. In winter,, this switch should be reversed (move to UP position) so that the blades now move in a clockwise direction. Select the desired position of the reverse switch on the lower canopy of the fan. - Page 9 The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
-
Page 10: Troubleshooting
TROUBLE SHOOTING: TROUBLE PROBABLE CAUSE SUGGESTED REMEDY A/ Fuse or circuit breaker has A/ Check main and branch circuit blown. breakers. B/ Loose wire connections to B/ Check line wire connections to Fan will not start the fan. fan. C/ Speed controller not in the C/ Check speed controllers position.
Need help?
Do you have a question about the DAYNE and is the answer not in the manual?
Questions and answers