Identification Of Parts; Assembly; Operation - Texas A/S WR1080 User Manual

Identification of parts

Figure 1
1 On-off switch
2 Switch lock
3 Additional handle lock
4 Control-pole lock
5 Control-pole plug
6 Wheel
7 Guard
8 Brush
Figure 3
1 Tube
2 Motor part
3 Battery
4 Guard
5 Screws
6 Nylon brush
7 Wire brush
8 wheel
9 Roller Nut
10 Front handle (not correct illustration)
11 Knob
12 Nut
13 Spanner
14 Crowbar
15 Charger

Assembly

Figure 4-5
Connect the handle part and motor part.
Insert the lead into the hole on the motor part, then
insert the hand part into the hole. (fig.4)
Push the hand part to the suitable location. (fig.5)
Figure 6-7
Mounting the wheel.
Insert the axle of the wheel into the mounting hole.
(fig.6)
Push the wheel to the suitable location. (fig.7)
Figure 8-9
Mounting the guard.
Mount the guard to the appliance as. (fig.8)
Fastening the guard with two screws. (fig.9)
Figure 10-11
Mounting the brush.
Mounting the brush on the roller, then wring the roller
nut on the roller. (fig.10)
Insert the crowbar into the hole on the roller and tighten
the roller nut while holding the crowbar. (fig.11)
In order to remove the brush, proceed in reverse order.
Warning!
Always take away the battery before inserting or
removing a brush
Figure 12
Mounting the additional handle.
Fit the addition handle (1) into the pedestal (2) and
adjusting the angle of the addition handle, tighten the
addition handle with knob and nut from both sides of the
addition handle.
Figure 13
Adjusting the height
Warning!
Not to start the appliance when adjusting the height, if
not will result serious harm.
Loosen the knob (1), one hand holds the front part (2)
of the hand part, the other hand holds the upper
aluminum pipe (3), catch the telescopic pole plug (2)
with one hand, and catch the telescopic top tube (3)
with the other hand, adjust to suitable position. Then
tighten the knob (1) according to the red arrow direction
as below picture showed.
Figure 14
Charging the battery
The charger is including two parts that the adapter (a)
and the charger pedestal (c).
Don't use other type of charger.
This charger is only use for this type of battery.
Please observe the specified voltage, the mains voltage
must same as that marked on the rating plate of the
battery charger.
Warning!
When the appliance is stopped, don't start the
appliance again.
The battery is not full charged when delivered, please
ensure it is fully charged before you use it the first time.
Charge it 5 hours the very first time.
If the machine cannot work when turn on the switch, it
means the battery is out of power, Recharge it.
Always disconnect power before changing brush!
Remember!
You can buy additional brushes:
Nylon brush:
Steel brush

Operation

Use the electric weed cleaner to remove weeds
between flagstones and pavers.
Adjust the support handle, so you have the best
possible control of the machine
Activate brush by activating handle with fingers, while
locking mechanism on the side of the handle is
activated. Release both to stop.
Do not press the brush down onto the surface. This will
increase the pressure on the brush and decrease its
working life. Extension cords longer than 50 feet must
not be coiled, but must be rolled out, lying loosely on
the ground.
Move the brush forward and backwards between the tile
grooves. It is most effective when the brush is being
pulled backwards.
Art. no. 90063100
Art. no. 90063090
10