Advertisement
DISASSEMBLY CONTINUED
6a.
Remove all three adjustment clips by lifting and pulling the clip from
the dispenser tube.
REASSEMBLY
1a.
Attach adjustment ring by dropping trim
ring around the dispenser tube; ensure
that the post for the thumbnut is aligned
with opening on adjustment ring.
3.
Align trim ring & locking tabs
with the slots on the dispenser
tube.
7a.
Insert assembled dispenser back into installed mounting flange and
rotate clockwise to secure unit.
San Jamar
555 Koopman Lane
Elkhorn, Wisconsin 53121
USA
T: +1.262.723.6133
F: +1.262.226.8664
info@sanjamar.com
www.sanjamar.com
© Copyright San Jamar, Inc. 2018
6b.
1b.
Tighten thumbnut with a
flathead screwdriver or a dime
to secure the adjustment ring.
4.
Apply downward pressure to
attach trim ring. When properly
aligned, the trim ring will snap
into place inside the dispenser.
7b.
Canada
Europe
3280 Bloor Street West
Schoorstraat 26a, bus 1
Suite 1140
2220 Heist-op-den-Berg
11th Floor, Centre Tower
BELGIUM
Toronto, ON M8X 2X3
T: +32 15 22 81 40
CANADA
F: +32 15 22 81 48
T: +1.262.723.6133
emea@sanjamar.com
F: +1.262.226.8664
canada@sanjamar.com
7a.
Remove the thumbnut that is
located on the underside of
the adjustment ring using a
flathead screwdriver or a dime.
2a.
Insert adjustment clips by threading them into the
slots on the body of the tube. When fully inserted they
should appear as pictured.
5.
Insert the pusher.
México
Av. Paseo de la Reforma No. 350 - 10
Col. Juarez
Deleg. Cuauhtemoc, CP 06600
MEXICO, D.F.
T: +52 (55) 3626 0772
mexico@sanjamar.com
©Copyright San Jamar 2018
7b.
Remove adjustment ring
by lifting up and over the
dispenser tube.
2b.
6.
Insert both the spring and
end cap.
103391_RevA
Advertisement
