Walinga Chem-Veyor 2614D Operator's & Parts Manual page 23

6 TROUBLE SHOOTING (CONTINUED)
PROBLEM
Slow capacity on
the discharge side.
(continued)
Pulsation or erratic
conveying.
Vacuum blower
overheating.
Pressure blower
overheating.
Hydraulic System
Overheating.
Engine shutdown
without warning.
Loss in drive speed.
CAUSE
Improper blower speed.
Relief Valve.
Timer control faulty.
Not enough air flow.
Low oil level.
Vacuum gauge exceeding 15 HG.
Discharge muffler plugged.
Noisy blower or knocking.
Low oil level.
Pressure gauge exceeding 9 psi.
Intake filter plugged.
Low oil level.
Oil filter plugged.
Breather plugged.
Poor oil quality.
Low oil pressure switch.
High coolant temperature.
Low coolant level switch.
Belts slipping.
Chem-Veyor Operator's & Parts Manual # 34-92547-6
SOLUTION
Check belt tension. Engine RPM.
Plugged discharge pipe. Check or
replace.
Replace
Control product flow, adjust air
intake by the suction nozzle
Open vent on railcar
Add oil as required, check for oil
leaks-repair.
Relief valve seized-free up
Clean or replace.
Consult factory or Dealer
Add oil as required, check for oil
leaks-repair.
Adjust product regulator.
Discharge line plugged.
Clean or replace.
Check and add oil, check for
leaks.
Replace a maximum of once per
year.
Clean or replace.
Change, consult with factory or
dealer.
Check oil level(see engine
manual).
Check water level only on level
gauge, DO NOT OPEN CAP
WHEN HOT!
Check level, and check for leaks.
DO NOT OPEN CAP WHEN HOT!
Tighten belts as required, or
replace.
21