Kia Sportage 2008 Manual page 142

7/6/12 https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM...
Avoid damaging connectors during the inspection process.
3. Are any problems found?
► Go to next step.
► After repairing the trouble part, check whether DTC occurs or not.
Inspection Procedure
1. PREPARATION
(1) Turn the ignition switch to LOCK.
(2) Disconnect the negative (­) terminal from the battery and wait for at least 3 minutes.
(3) Remove the DAB module and disconnect the DAB connector.
(4) Disconnect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(5) Disconnect the SRSCM connector.
2. CHECK SIS CIRCUIT
(1) Measure resistance between the terminal 1 of SIS harness connector and the terminal 42(39) of SRSCM harness
connector.
(2) Measure resistance between the terminal 2 of SIS harness connector and the terminal 41(40) of SRSCM harness
connector.
specification(resistance) : below 1 Ω
(3) Is the measured resistance within specification?
►Check Side Impact Sensor.
► Repair or replace the wiring harness between the SIS and the SRSCM.
3. CHECK THE SIDE IMPACT SENSOR
(1) Replace the Side Impact Sensor(SIS) with a new one.
● Refer to "Side Impact Sensor(SIS)" section in this SERVICE MANUAL.
(2) Install the DAB module and connect the DAB connector.
(3) Connect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(4) Connect the SRSCM connector.
(5) Connect the negative (­) terminal to the battery.
(6) Connect a Hi­Scan(Pro) to the data link connector.
(7) Turn the ignition switch to ON and check the vehicle again.
Does Hi­Scan (Pro) indicate any DTC related to Side Impact Sensor(SIS)?
► Go to next step.
► Replace SIS.
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM... 142/227