Advertisement
INSTALLATION INSTRUCTIONS
EMERGENCY INSTALLATION
NOTE: PLEASE FOLLOW ALL THE STEPS ON PAGE 2 FOR STANDARD INSTALLATION. ONCE COMPLETED PLEASE
FOLLOW THE STEPS BELOW TO ENSURE PROPER INSTALLATION OF THE EMERGENCY BATTERY PACK.
EMERGENCY
TEST SWITCH &
INDICATOR LIGHT
LED DRIVER
© 2018 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
P/N 443560819190 Rev A
Page 3 of 4
PUREFORM BOLLARD (PBL)
1.
2.
3.
2X 1/4-20x5/8"
4.
HEX HEAD SCREWS
5.
EMERGENCY
BATTERY PACK
EMERGENCY
DRIVER
UNSCREW (2) 1/4-20X5/8" HEX HEAD
SCREWS FROM TOP OF BOLLARD
SHAFT TO DETACH THE YOKE AND EX-
POSE THE DRIVER BRACKET.
COMPLETE THE CONNECTION AS
SHOWN BETWEEN THE TWO RED
WIRES. THIS MUST BE CONNECTED SO
THAT THE EMERGENCY BATTERY
PACK STAYS CHARGED.
ONCE CONNECTED CAREFULLY SLIDE
BOLLARD YOKE WITH ATTACHED DRIV-
ER BRACKET BACK INTO THE SHAFT.
MAKE SURE NOT TO PINCH ANY
WIRES.
ALIGN SCREW HOLES ON YOKE, GAS-
KET, AND SHAFT. TIGHTEN THE TWO
1/4-20x5/8" HEX HEAD SCREWS THAT
WERE REMOVED IN STEP 1 TO 10 FT-
LBS.
ONCE LUMIANIRE IS POWERED ON EN-
SURE THAT TEST INDICATOR LIGHT
TURNS ON. FOR A SHORT TIME TEST
(30 SEC) , LET THE UNIT CHARGE FOR
AT LEAST AN HOUR BEFORE PRESSING
EMERGENCY BUTTON TO ENSURE
BOLLARD CAN SWITCH OVER TO
EMERGENCY BATTERY POWER.
Advertisement
