Weak Or Hard To Hear Audio - Uniden DCX210 User Manual

If...
The phone keeps
ringing if I answer on
an extension.
The answering system
does not work.
The answering
system won't record
messages.
A handset can't access
the answering system.
My outgoing message
is gone.
I can't hear the base
speaker.
Messages are
incomplete.
The system keeps
recording if I answer
on an extension.
I can't register a
handset.

Weak or Hard To Hear Audio

If a caller's voice sounds weak or soft, the signal might be blocked by
large metal objects or walls; you might also be too far from the base,
or the handset's battery may be weak.
Try moving around while you're on a call or moving closer to the

base to see if the sound gets louder.
Make sure the handset's battery is fully charged.

Try adjusting the earpiece volume or the audio tone (see below).

Adjust the audio tone
During a call, open the menu and select Audio Tone. Choose one of
the three audio tone options: High Tone, Natural Tone (recommended
for hearing aid users), or Low Tone. You may have to experiment to
figure out which audio tone works best for you.

Try...
-
You may have to change the line mode. Contact
customer service for more information.
-
Making sure the answering system is turned on.
-
Making sure the base AC adapter is not plugged into
an that's controlled by a wall switch.
-
Making sure the Record Time is not set to
Announce Only.
-
Deleting messages (the memory may be full).
-
Making sure no other handset is using the system.
-
Making sure the phone is in standby.
-
Seeing if there was a power failure. You may have to
re-record your personal outgoing message.
-
Making sure call screening is turned on.
-
Changing the base speaker volume.
-
The incoming messages may be too long. Remind
callers to leave a brief message.
-
Deleting messages (the memory may be full).
-
You may have to change the line mode. Contact
customer service for more information.
-
Seeing if there are 6 handsets registered to this base.
-
Resetting the handset.