Advertisement
1)
Mount the backplate by use of 2 screws.
The Endpoint must always be mounted in a vertical position, to ensure air flow
from bottom to top. The Endpoint may be turned around to allow cables to enter
from above.
2)
Connect the Ethernet cable for the Internet connection to Ethernet port 1
Note: If the Ethernet connection does not provide "Power over Ethernet" (PoE),
then use power supply item no. 383801 (EoC PSU for Ethernet Endpoint)
3)
Optional:
Connect the Ethernet output if required to Ethernet port 2.
This may be a PoE device, provided the Endpoint is powered from
a PoE+ compliant switch or powered by an external power supply
4)
Attach the Endpoint to the backplate and if power supply must be used,
then plug the power supply into the wall socket
5)
Wait for Endpoint to power up and log on to the WiFi SSID called TriaxSetup_xxxx
(the xxx is specific to your WiFi controller).
Scan the setup QR code with your mobile using a QR code scanner, or configure
the Endpoint through the GUI on the WiFi controller ( in 'Network' -> 'Endpoints').
Software:
https://www.triax.com/products/ethernet-over-coax/eoc-controller-32-2
https://www.triax.com/products/ethernet-over-coax/eoc-controller-64-4
How to install EoC Endpoint
- Ethernet with PoE/WiFi
How to install EoC Endpoint
- Ethernet with PoE/WiFi
6)
Follow the on-screen steps in the GUI > Click SAVE
7)
Mount the cover to finish the installation
Advertisement
