Advertisement
Quick Links
Advertisement
Related Manuals for Proper iPad Wall Mount
Summary of Contents for Proper iPad Wall Mount
- Page 1 Wall Mount Installation Guide...
-
Page 2: Before You Begin
Before You Begin Power Loosening and Tightening Screws This product includes a (2m) 8-Pin Lightning to USB cable. Overtightening the screws may cause damage to the wall Before installation, ensure your device is within reach of mount, or your device. If you feel as though something isn’t a power source. -
Page 3: Product Overview
Product Overview Apple iPad This product is designed to be compatible with Apple iPad (5th & 6th Generation). (Not included with the stand) Powered iPad Lock Belt This is the ‘belt’ that secures your iPad in place, conceals the charging cable, and keeps your device securely attached to the wall mount. - Page 4 The Toolkit Hex Key / Pick Tool Security Tool Use the Hex Key for hexagonal Use the Security Tool for star screws shaped like this. shaped screws like this. The Pick Tool is used to lift off end caps.
-
Page 5: Mounting Options
Mounting Options Tail Tunnel Tailing your cable from the bottom Tunneling your cable through the of the stand requires you to feed the wall requires you to make a hole cable through the stand before you (Ø 15-25mm) beneath the stand. secure it to the wall. -
Page 6: Additional Components
Additional Components These components are not included, but are required for installation. As the Wall Mount can be mounted onto a variety of surfaces, we are unable to provide certain hardware to assist in mounting to every wall. You will need to source the appropriate tools for your particular use case. - Page 7 Safety Notice As this product requires drilling into the wall, ensure you take into consideration the possibility of live power, gas lines, water lines, or other plumbing and utility hazards. Interference with the mains electricity can result in death. If you are in any way uncertain about the safety of the surface you are mounting to, we recommend consulting a licensed professional installation contractor.
- Page 8 Use the Pick Tool to lift off the metal end caps from the Lock Belt. Use the Security Tool to remove the 4 screws holding the cassette in place.
- Page 9 Use the Security Tool to remove the 2 screws holding the end cap on. Position the iPad into the frame and tighten with the security screws. Note: Ensure the Lightning port is aligned in the correct orientation. (See Home button indentation)
- Page 10 5. Using the Hex Key, remove the 4 screws holding the Lock Belt frame to the body of the Wall Mount.
- Page 11 On your wall, measure out and mark the points where you will be drilling. Note: We recommend using a spirit level for perfect alignment. 25mm If you intend to tunnel the charging 50mm cable through the wall, you must also make a 15-25mm hole in the centre of the mounting position.
- Page 12 7. Screw the Wall Mount into the wall. Note: As the Wall Mount can be mounted onto a variety of surfaces, we are unable to provide certain hardware (such as screws) to assist in mounting to every wall. You will need to source the appropriate tools for your particular use case.
- Page 13 Using the Hex Key, re-attach the 4 screws holding the Lock Belt to the body of the Wall Mount.
- Page 14 Connect the Lightning cable to the iPad. There are clips underneath to hold it in place. Pass the USB end of the cable through the wall mount.
- Page 15 Use the Security Tool to attach the iPad to the frame. 12. Push the end caps back onto the frame to secure the iPad in place.