Related Manuals for Nagra Classic PSU
Summary of Contents for Nagra Classic PSU
- Page 1 Classic PSU Super-cap power supply User manual P/N: 2055050159 All rights reserved – © 06/2018...
-
Page 2: Table Of Contents
Operating the CLASSIC PSU ................. 8 Nagra Modulometer ................. 8 LED and Modulometer intensity adjustment ..........8 Remote control ..................8 Starting the CLASSIC PSU using the trigger input ........10 Using the trigger outputs ................ 10 Case cleaning ..................10 Technical specifications ................11 EU Declaration of conformity .............. -
Page 3: Safety Warning
(validated by the serial number on the device casing and the invoice from an official Nagra dealer). This warranty is only valid for the original purchaser of new equipment. -
Page 4: Congratulations
Congratulations Congratulations! You have just acquired a fine piece of equipment. The CLASSIC PSU was created by an engineering team with more than 65 years’ experience designing world-class products for the professional audio, national security and military businesses. Ever since its creation in 1951, Nagra has built devices that offer exceptional sonic performance. -
Page 5: Installation
Nagra CD mechanics. Feel free to contact your Nagra dealer for more information. it is not advised to place other Nagra units above or below the CLASSIC PSU, as it features a large transformer. It is preferable to use a separate shelf for other devices. -
Page 6: Front Panel
Connecting the mains Place the front panel selector in the OFF position, marked “O”. Insert the IEC cable into the connector on the rear of the Nagra CLASSIC PSU. You may then push the mains switch to the “I” position. -
Page 7: Which Output To Use
If you have purchased the optional third output, then it is active, otherwise only outputs 1 and 2 are used. Connecting your Nagra gear to the CLASSIC PSU Please note that the LEMO plug features a red dot that must be facing upwards for correct insertion into the power connector. -
Page 8: Operating The Classic Psu
These are the functions available from the main selector. The CLASSIC PSU is in standby position (Remote) The CLASSIC PSU will be turned on and off by the remote control, or the input trigger, for more information see page 9... -
Page 9: Remote Control
Then open the top plate. The selector is on the front panel board, on the right-hand side. 0 position is for Philips RC 5 format –1 to 6 is to use Nagra RCU and RCU II device number, simply turn the selector to the number you wish the CLASSIC PSU to respond to. -
Page 10: Starting The Classic Psu Using The Trigger Input
When powering down, these outputs will be turn off first. Case cleaning Clean the CLASSIC PSU casing using a soft, non-fluffy, slightly damp cloth. Do not use any cleaning products which could have a corrosive effect. Nagra –... -
Page 11: Technical Specifications
Technical specifications Compatibility Nagra VPS, Jazz, Melody preamplifiers, Classic DAC, HD DAC, Classic PREAMP, Nagra CD players Output type 1 to 3, 12 V DC, 1.5 A Lemo pin 2-3 GND contact - command Lemo pin 1 Linear noise 30 μV maximum... -
Page 12: Eu Declaration Of Conformity
EU Declaration of conformity Nagra – Classic PSU...