Advertisement
'' DOUBLE LIGHT '' SERIES FOR MAINTAINED LUMINAIRES
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES (Ni-Cd)
BATTERY PROTECTION
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
FLUORESCENT LAMP
ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
These luminaires are used in places where
emergency luminaires are needed.
Each luminaire must be permanently connected to
mains power supply.
In normal operation the battery is charging and the
lamp lights in maintained operation.
In case of a mains power supply failure the
luminary will light the lamp automatically in
emergency mode. When the mains power supply
is restored the device turns to normal operation.
ÁÔÔÅÍÔÉÏÍ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel only.
2. The device must be connected to the mains
power supply thru a fuse dependent by the total
amount of the line's power load.
3. It is sugested to check every month the indication
LED for battery charging, and by pushing the TEST
button to check the emergency cirquit. The lamp
should light as long as the TEST button is pressed
In the opposite condition contact the installer.
4. It is sugested to check every 6 months the
1. Detach the plastic base (located in the bottom of the luminaire) by pulling the unlock hook and pass the cables
thru the respective hole. Mount the plastic base with the included mounting accessories.
2. Connect the cables to the terminal blocks as showed.
3. Attach the luminaire by sliding it on the plastic base until the plastic hook locks, and power the luminaire.
230V AC
L
N
Cables
pass thru
hole
EM 2774
23 VA
2.4V/1.5Ah
Battery charging LED, TEST button
90min
315lm (230V AC) / 85lm (emergency)
EN 60598-1, EN 60598-2-22
Bayblend FR3010, transparent polycarbonate
970gr.
3 years (1 year for the lamp and the battery)
minimum autononous duration by disconnecting the
mains power supply. Count the time that the lamp
lights and in case of less time than the minimum
autonomous duration the battery must be replaced. If
the measured time is considerably less than the
minimum autonomous duration
In case of battery or lamp replacement, these must
be replaced by parts of the same type
5.
It is sugested
hours of continuous operation
6. In case of inactive use for a period greater than 2
months, disconnect the battery by pulling out the
battery's connector.
7. I s not allowed to discard batteries in to
t i
common trash bins, they must be discarded only
in battery recycling points. Do not incinerate.
INSTALLATION
To install the luminaire follow the installation
instructions bellow.
.
Plastic base
EM 2775
220-240V AC/50-60Hz
From full discharge
24h
8W (T5)
IP 20
o
0 to 40 C
Up to 95%
332 x 100 x 205 mm
to replace the lamp every 8000
.
24 VA
2.4V/3Ah
3h
1040gr.
contact the installer.
.
Lock - unlock hook
923516000_09_004
Advertisement
