BCG Traditional Series Instructions Manual page 10

T R A D I T I O N A L S E R I E S S T R A I G H T M O D E L • G R E E N H O U S E I N S T R U C T I O N S
Front Gable End
Assembly
4. Take all the glass bars (next to the
door frame - see Pic #4 on Page 7)
and bolt them to the base/sill.
The angle cut should match the
roof slope. (See Pic E.)
The 1" x 2" angle above the door
(50" long) can now be bolted on.
The 1/4" round holes should be
lined up with the holes in the
plates. (See Pic F.) Each end of the
1" x 2" angle has a slot punched
out to accommodate the bolt that
is lined up with the glass bars 24
1/2" from the center.
Slide a bolt in the top of the glass
bar and fasten the angle to it.
(See Pic G.)
E
(contd.)
F
G
– 9 –
F