Shed Care And Safety; Assembly Day Tips - Craftsman 65018 Assembly Instructions Manual

SHED CARE AND SAFETY

• Hot items, such as recently used grills, blowtorches,
etc., must not be stored in the shed.
• Heavy articles should not be leaned against the
walls, as this may cause panel distortion and
permanent damage.
• Keep roof clean of snow and leaves.
• Your product is made of materials that will withstand
outdoor use. Exposure to the elements (such as
dust, plant and animal life, moisture and sunlight)
encourages moss, algae, and mold to grow on
outdoor items. To maintain the look of your product,
we recommend cleaning it each year with mild
soap and water. DO NOT use bleach, ammonia, or
other caustic cleaners, and DO NOT use stiff bristle
brushes. Failure to perform annual cleaning could
result in permanent staining of the plastic. This is
not a manufacturing defect and is not covered under
warranty.
PRODUCTS AND REPLACEMENT PARTS
To purchase replacement parts call.
1-855-239-0261

ASSEMBLY DAY TIPS

• Complete site preparation and foundation
construction before unpacking parts and
beginning assembly.
• DO NOT attempt to assemble on a day with strong
winds.
• DO NOT attempt to assemble on days when
temperature is below 32 degrees.
• Set aside appropriate amount of time to completely
assemble shed.
• Make sure you have assistance nearby to lift and
secure parts in place.
• Wear light duty work gloves while assembling shed.
• Once roof is assembled, a flashlight may be of use
when assembling smaller components inside shed.
• DO NOT use a torque wrench or hand drill to
tighten provided Easy bolts. Use 010210410 Easy
Bolt Easy Driver tool (provided) ONLY.
• Extra hardware is provided for small fasteners for
customer convenience. In some cases, there will be
extra small fasteners once the assembly is complete.
Note: This product contains parts that are used in
different orientations to construct the shed. Please take
note of the orientation of the parts shown throughout
this instruction manual. Failure to follow instructions
could result in damage to parts. Manufacturer is not
responsible for replacing parts lost or damaged due
to incorrect assembly.
3