Schonberg MT-RT1802 Instructions Of Installation And Use

Advertisement

Preparations

Cleaning & Maintaining
1. During the transportation or installation, do not pull the pipe or hold
the water leakage.
2. After long time use, if there are some dirt on product s surface, wipe it off gently by a
soft towel stained with mild detergent; for the metal parts, polish it with some car wax by
a towel, which brings out a refreshing appearance.
3. Scale deposit can be wiped off with warm citric acid or vinegar by a soft cloth.
,
4. Don t clean the tub and
accessories
with hard or coarse material to avoid any scratches.
,
5. Don t clean the tub and
accessories
with gasoline to avoid any damages.
6. It is not recommended to leave water in the tub for a long time or use this tub for
washing purpose. Pls drain off the water after the bath and dissconnect the power supply.
7. There should be sufficient power supply and wires should be safely grounded.
8. For your safty, a professional technician is necessary to ensure earthing wire be well
grounded and a RCCB fitted during installation.
www.schonberg bathrooms.com
accessories
to avoid
,
Dortmund/Hannover
Massage Bathtub
Instructions of Installation and Use
www.schonberg bathrooms.com
MT-RT1802

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MT-RT1802 and is the answer not in the manual?

Questions and answers

Summary of Contents for Schonberg MT-RT1802

  • Page 1 Dortmund/Hannover Preparations Massage Bathtub Cleaning & Maintaining Instructions of Installation and Use www.schonberg bathrooms.com 1. During the transportation or installation, do not pull the pipe or hold accessories to avoid the water leakage. 2. After long time use, if there are some dirt on product s surface, wipe it off gently by a soft towel stained with mild detergent;...
  • Page 2 Preparations Dear Customer, Thank you for choosing our product. For your safe concern, please take a few minutes to read this manual before installation and use. Please make sure all accessories are in the package Pillow (Bathtub 1set Accessory box 2pcs Pillow 2pcs) WARNING 1.
  • Page 3 2. Remove the screw of inlet faucet shows 650mm 300mm 400mm Drain hole MODEL: MT-RT1802 3. Put the inlet faucet into the 4. Put the rubber from below, and SIZE: 1800mmX900mmX650mm Volume Control hole of the bathtub use spanner to screw it...
  • Page 4 Installation Process Installation Process 1. Open the accessory box 2 as pic. 2. Put the shower head into the bathtub 7. Make the thread sealing tape smooth 8. Fasten the drain tube shows in right position as pic. shows 3. Distinguish water inlet pipe 4.
  • Page 5 Instruction of Using Our Products Installation Process 13. Seal the barthtub edge by silicon glue as follows System Installation Sketch MAIN CONTROL BOX PANEL LEAKAGE SENEOR PROTECTOR CTRL LINE H M M Unique Point SKIRT LAMP WIND PUMP SPEAKER WATER HEATER PUMP WATER DETECT...
  • Page 6 Instruction of Using Our Products Instruction of Using Our Products Run Condition Precautions 1. Power: AC110V/220V 1. The installation should be carried out by a qualified technician and creepage protector 2. Underwater Lamp: AC12V should be installed in the place easily to be controlled. 3.

Table of Contents