Steps
1. Using the alignment posts, place the battery on the palm-rest and keyboard assembly.
2. Replace the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
3. Connect the battery cable to the system board.
4. Adhere the tape that secures the battery cable to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Baterai sel berbentuk koin
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
NOTE:
Removing the I/O-board cable is equivalent to removing the coin-cell battery. It resets the BIOS setup
program's settings to default. It is recommended that you note the BIOS setup program's settings before removing
the coin-cell battery.
2. Remove the
base
cover.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
18
Melepaskan dan memasang komponen
After working inside your
computer.
Before working inside your
computer.