5. Operation sequence in passive cable route detection mode
Used equipment:
5.1 Connection of sensors and check of the receiver operability
1. Connect the electromagnetic sensor and
headphones to the corresponding receiver
connections headphones (if necessary)
2.2 Loosen the locking nut (1) and install the electromagnetic sensor
(2) in a position used in route detection. Fix the position with the
locking nut. Horizontal position – is used for route detection by
maximum method, and transport position for route detection by
minimum method
receiver
AP-027
sensor EMD-247
1.
electromagnetic
Fig. 5.1
2.1 To set the electromagnetic sensor from
transport to operating position. In order to do
that: loosen the locking nut (1), extend the
bar (2) to a required length and fix with the
12
headphones
locking nut
1.
the receiver
2.
2.
3. Turn on
AP-027