Table Of Contents - Toro Greenmaster Flex 1820 Operator's Manual

This product complies with all relevant European
directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
WARNING
CALIFORNIA
Proposition 65 Warning
Use of this product may cause exposure
to chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Introduction
This cutting unit is designed for cutting turf on greens
and small fairways of golf courses.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
1. Location of the model and serial numbers
© 2018-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Figure 1
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure 2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Contents
Safety ....................................................................... 3
General Safety ................................................... 3
Safe Operating Practices.................................... 3
Safety and Instructional Decals .......................... 4
Setup ........................................................................ 5
Installing the Roller ............................................. 5
Preparing the Cutting Unit for Use on an
eFlex Machine ................................................ 5
Installing the Push Nut (CE Only) ........................ 6
Adjusting the Cutting Unit ................................... 7
Product Overview ..................................................... 8
Specifications .................................................... 8
Attachments/Accessories ................................... 8
Operation .................................................................. 8
Maintenance ............................................................. 9
Supporting the Cutting Unit................................. 9
Adjusting the Bedknife-to-Reel Contact .............. 9
Adjusting the Rear-Roller Height....................... 10
Adjusting the Height of Cut ................................11
Adjusting the Clip Setting.................................. 12
Adjusting the Cut-Off Bar .................................. 13
Servicing the Bedbar ........................................ 13
Bedknife Specifications .................................... 15
Backlapping the Cutting Unit............................. 17
g016942
2
Figure 2
Contact us at www.Toro.com.
Printed in the USA
All Rights Reserved
g000502