Advertisement
1. IMPORTANT SAFETY INSTRUCTIONS
1. To prevent fire or shock hazard, do not expose any part of the
devices to rain or moisture.
2. This product is for indoor use only
3. Do not install near any heat sources such as radiators, heat
registers, stoves or other apparatus (including amplifiers)
that produce heat.
4. Clean only with a dry cloth.
5. Protect the power cord from being walked on or pinched
particularly at plug, convenience receptacles, and the point
where it exits from the apparatus.
6. Unplug this apparatus during lightning storms or when unused
for long periods of time.
7. Refer all servicing to qualified service personnel.
8. Do not expose this equipment to dripping or splashing and
ensure that no objects filled with liquids, such as vases, are
placed on the equipment.
9. This device should be operated using only the AC/DC adaptor
supplied with it.
10. Do not overload wall outlets and extension cords as this can
result in the risk of fire or electrical shock.
2. CONTENTS
1x HDMI Transmitter
1x HDMI Receiver
1x Wideband 20-60kHz IR Blaster
1x Wideband 20-60kHz IR Receiver
1x 5V 2A DC Power Supply Adaptor
1x Owner's Manual
3. CONNECTIONS
Transmitter: HDMI with HDMI Loop-out to CAT
①
②
③
④
1. For IR Blaster Cable
2. CAT Output
3. Reset
4. DC5V Power Input
Receiver: CAT to HDMI
①
②
③
1. DC5V Power Input: if low quality
CAT cable is used, you may need
to use an additional DC5V power
adaptor (sold separately) to amplify
the signal. With full Copper CAT6
cable up to 55m, no power is
required (PoE)
2
4. INSTALLATION
⑤
⑥
⑦
5. HDMI Loop-out
6. EDID
1. Connect a source device to the HDMI Input on the Transmitter.
7. HDMI Input from source
2. If using the HDMI Loop-Output, connect a display to the HDMI
3. Connect a single CAT 5e/6/7 up to 55m from the CAT Output
4. Connect a display from the HDMI Output on the Receiver.
5. If using the IR cables, connect the IR Blaster to the IR IN in the
6. Plug the power supply into the Transmitter DC5V power socket
④
⑤
⑥
2. HDMI Output to display
5. EDID
3. For IR Receiver Cable
The display used within an installation may not support all
4. Sync: pairs the units
resolutions available from a source. It is necessary to make sure
5. CAT Input
the source will provide a video and audio format compatible with
6. Link: LED is ON when
the connected display. To accomplish this, the Transmitter
an HDMI output is
includes built-in EDID management for the source input.
detected
3
4
CAT5e/6/7
Out on the Transmitter.
of the Transmitter to the CAT Input of the Receiver.
Transmitter; and the IR Receiver to the IR OUT on the Receiver.
and plug the power adaptor into a mains socket.
4
Advertisement
