U-Line 2275DWRWOL Use And Care Manual page 19

3. Press the left rack release lever (Figure 26) down, and
at the same time, lift the corresponding right rack
release lever up, and pull the rack out until it is free of
the tracks and the cabinet.
IMPORTANT IMPORTANT
Do not remove the track side rails from the cabinet.
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks
in the cabinet, and ensuring an even track
engagement on both sides, gently push the rack into
the cabinet until it stops.
2. Before reloading the rack, ensure proper operation of
the travel stops in the left and right track rails by
pulling the rack out gently until it completely stops.
Wood Trim Finishing
®
The U-Line Wine Captain
trimmed wine racks that are coated at the factory with a
clear vinyl sealer, which will adequately protect the wood
in normal usage. A final finish coat was not applied so
that the wood trim could be stained to match décor. The
trim on the racks may be coated with a final finish or
stained.
WARNING
To prevent permanent damage to the inner liner
of your unit, the wood trim MUST be removed
from the unit for staining and/or finishing. Allow
stain/finish to dry thoroughly (at least 24 hours
per coat) in accordance with the product
manufacturer's instructions prior to
reinstallation. Failure to do so may cause the
inner liner of the unit to have a permanent odor,
which is not covered by the warranty.
If staining the trim is desired, it must be done before the
application of any type of final finish. Review the
following staining/final finish and final finish-only
guidelines when staining/ and or sealing the wood to
ensure proper adhesion and durability of the finish.
NOTE: Glass in door is tinted. Stain may look darker
when door is closed.
is equipped with wood-
2275DWRWS, 2275DWRWOL
Staining and final finish application:
1. Remove all screws securing wood trim to interior
components, and remove the trim from the cabinet
interior.
To remove the top drawer display wood trim:
5
3
Figure 27
2. Remove the two screws (Figure 27, 1), securing trim
to wine rack assembly (Figure 27, 2).
NOTE: Your model will contain an electronic display panel
(Figure 27, 3) in the middle level trim piece. After
removing the trim screws, and gently pulling the trim
from its location, a wiring harness connector
(Figure 27, 4) will become visible. Unplug the connector.
3. Remove the two screws, securing the electronic control
to the wood trim. Carefully rotate the wood trim so the
electronic control slides out of the wood, and place the
electronic control aside in a safe location.
NOTE: The electronic control and glass front are NOT
connected. Be careful when removing the control
not to drop the glass.
3
Figure 28
4. Remove the two screws (Figure 28, 1) securing trim to
wine rack assembly (Figure 28, 2).
1
4
ULIN_0831_A
1
2
ULIN_0145a_A
19