Keisue KES1.0 Instruction Manual page 25

（2）Switch Mode
(1) Vegetable Mode, Seedling Mode and Sprouts Mode can be switched randomly before entering
Custom Mode
(2) If it is at Custom Mode, press the "OK" button to exit, and hold one of the Fixed Mode
(Vegetable/Seedling/Sprouts) to enter that particular Mode.
（3）Time Edit
Hold both "+" and "-" together for 6 seconds to enter "Time edit" Mode (Timer will stop), the default
"Hour" of the digital display flash. Press "+" or "-" to set "Hour". Then press the "SET" button to enter
"Minute" setting. "Minute" of the digital display flash, Press "+" or "-" set "Minute". Setting can be
exited automatically either by pressing "OK" button or hand off for 10 seconds. Clock will time again.
（4）Switching between Celsius and Fahrenheit ( ◦C or ◦F)
Long press "+" for 6 seconds to interchange ◦C and ◦F, data can be saved even power off, the default is
Celsius.
（5）Fault code display
(1) Communication Fault: Temperature, Humanity display "Er"
(2) Temperature probe failure: temperature displays "C1"
(3) High temperature fault: the temperature displays "HA" (alternately display with room temperature) -
--lights turn off
(4) Low temperature fault: the temperature displays "Lo" (alternately display with room temperature)
(5) Humanity probe failure: Humanity displays "P1"
(6) Evaporator failure: temperature displays "E1" (alternately display with room temperature or
C1/HA/Lo)
（6）Testing Mode
Under Non-Setting Mode, hold the "OK" button to enter Testing Mode, all the icon will light up in the
screen (except "Load" icon), "Load" icon closes. At this moment, press "vegetable" button to controls
the On/Off of Plant Light 1's; "Seedling" button controls the On/Off of Water Pump 1; "Sprout" button
controls the On/Off of fans; "SET" button controls the On/Off of Plant Light 2; "+" button controls the
On/Off of Water pump 2; "-" button controls the On/Off of all icons; hold the "OK" button 6 seconds to
exit the Testing Mode.
（7） Background Light Power Saving Mode
If any button is not held for 30 seconds, the screen will enter Power Saving Mode. Under Power Saving
Mode, press any button to exit. Press any button to control KES1.0/KES2.0 again.