Keisue KES1.0 Instruction Manual page 12

4.2.1.4 Prepare the Tray
(1) Make sure every tray is clean, sanitize or sterilize if necessary.
(2) Plug in the pump cord into the socket for the pump at the top left corner of each layer.
(Default is connected.)
(3) Plug in the Grow Light cord into the socket for the light at the top left corner of each layer.
(Default is connected.)
(4) Add water to each tray until water level reach the "2.5" mark. (Figure 5)
(5) Close the tray cover.
Notes:
i. The cup / measuring glass can be used to pour the water into the tray.
ii. Pump should be switched ON after water level reach to the "0.5" mark;
otherwise the water shortage protection will be activated
4.2.1.5 Switch on the Pump / Grow Light / Vegetable mode
(1) Two leaves will appear after 3-5 days
(2) Then move the baskets/pots with buds to the 3rd layer grow tray.
(3) Turn on the pump switch of the 3rd layer. (Figure 7)
(4) All pump switches are "OFF" by default, turn it "ON" for the 1st time.
.