Subscribe to Our Youtube Channel
Related Manuals for Pelonis FZ10-19JR
Summary of Contents for Pelonis FZ10-19JR
- Page 1 OWNER’S MANUAL Tower Fan MODEL: FZ10-19JR READ AND SAVE THESE INSTRUCTIONS Attention: Pictures in the IM are for reference only.
- Page 3 IMPORTANT SATETY INSTRUCTIONS CAUTION Read Rules for Safe Operation and Instructions Carefully. WARNING 1. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way.
- Page 4 ASSEMBLY INSTRUCTIONS 1. Take out the fan body and the spare parts from the box. 2. Put the front base onto the rear base and joint them together by aligning the four posts. (See Fig. 1) 3. Detach the plastic nut (See Fig. 2) from the fan body. 4.
- Page 5 5. “ ” TIMING KEY After the fan starts, press this key and set the time. Press it continuously to select time from 1-7 hours with an increment of 1. There will be signals on screen in the sequence of (=1 hour), (=2 hours), (=3 hours),...
- Page 6 II. Buttons on fan body / Panel indication (Fig.6) The buttons on the body such as ON/OFF,SPEED, MODE, TIMER, OSCILLATION have the same functions as those of the corresponding keys on the remote controller. ON/OFF Button: Turn on/off the tower fan. Fig.6 Speed Button: Press it continuously to choose “1-2-3”...
- Page 7 CLEANING 1. Be sure to unplug the fan from the electrical supply source before cleaning. 2. Plastic parts should be cleaned with mild soap and a damp cloth or sponge. Thoroughly to remove soap film with clean water. 3. Be sure not to make water or other liquid enter inside of motor.
Need help?
Do you have a question about the FZ10-19JR and is the answer not in the manual?
Questions and answers
When I attached the base to the fan body, if touched, it "wobbles". Should it ? Or should it be "rigid."
The Pelonis FZ10-19JR fan base should be rigid when attached to the fan body. The assembly instructions specify that the front and rear base must be joined by aligning four posts and secured by screwing a plastic nut at the bottom, which ensures stability.
This answer is automatically generated