HSS Hire 69313 Operating & Safety Manual

Ensure the ram' s pressure release valve is closed (turn fully
Operating & Safety Guide LS178
clockwise).
The force exerted by the hydraulic ram (up to a maximum
of 1,500kg) creates a potentially dangerous situation, so
make sure that any seal has been broken before lifting.
If great force is used, the assembly and manhole cover
will spring up.
NEVER place yourself in a position where you could be hit
by the equipment or cover as the cover lifts.
Using the pump handle, gradually pump the ram until
the manhole cover lifts.
Take your time and don't overdo it. You are more likely to
have an accident if you are tired or rushing.
Once raised, manoeuvre the unit away from the manhole
and lower the ram, by turning the pressure release valve 1 turn
anti-clockwise.
When replacing the cover, simply reverse the removal
procedure.

EQUIPMENT CARE

Never push the equipment beyond its design limits.
If it will not do what you want with reasonable ease and
speed, assume you have the wrong tool for the job.
Contact your local HSS Lift & Shift Depot for advice.
Keep the equipment clean, you will find this less of a
chore if you clean it regularly, rather than wait until the end
of the hire period.
When not in use, store the equipment somewhere
clean, dry and safe from thieves and unauthorised users.

FINISHING OFF

Hydraulic
Replace the manhole cover and disconnect all keys
and clamp frames.
Dismantle the unit and give everything a thorough
clean ready for return to your local HSS Lift and Shift.
Manhole
Cover Lifter
Contact your local
A hydraulically operated lifter with a
Lift & Shift
0845 704 5116
breakout of 1500kg
...any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 020 8687 5001
©HSS Hire Service Group Plc 2003 No. LS178/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Code 69313
Web Site: http://www.hss.com/liftandshift