Operation - Havso Jacob 2.0 User Manual

OPERATION

Before using your kettle
If you are using the kettle for the first time, it is recommended that you should clean
your kettle before use by boiling a full kettle of water twice and then discard the
water. Wipe the surface with a damp cloth.
Note: The max capacity of the kettle is 1.5 liter.
Dry-boil protection
If you accidentally let the kettle operate without water, the dry-boil protection will
automatically switch off the power. If this occurs, allow the kettle to cool before filling
with cold water and re-boil.
Use your kettle
1. To fill water into the kettle, remove it from the power base and open the lid. Fill
with the desired amount of water. Always fill the kettle between the minimum
(0.5 L) and maximum (1.0 L) marks. Too little water will result in the kettle
switching off before the water has boiled.
Note: Do not fill the water over the maximum level, as water may spill out of the
spout when boiling. Ensure that the lid is firmly in place before connecting the
power cord to the outlet.
2. Close the lid. Position the kettle on the power base in place. Make sure the
kettle contact with the power base completely.
3. Connect the plug into a power outlet. Press down the switch to "I" position and
the switch light illuminates. Then start to boil the water.
4. The kettle will switch off automatically once the water has boiled and the switch
light extinguishes. You can shut off the power by pressing the switch at any
moment during boiling water.
Note: Ensure that switch is clear of obstructions and the lid is firmly closed.
The kettle will not turn off if the switch is constrained or if the lid is left open.
5. Lift the kettle from the power base and then pour the water.
Note: Operate carefully when pouring the water from your kettle as boiling
water may result in scalding, besides, don't open the lid while the water in the
kettle is hot.
6. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20
seconds before reopening to boil water. The kettle may be stored on the power
base when not in use.
Note: Ensure power supply is turned off when the kettle is not in use.
12