Loll Designs NO. 9 COCKTAIL TABLE Assembly Instructions

ASSEMBLY INSTRUCTIONS
1
ATTACH BRACES
*Please read Assembly Tips before beginning assembly.
Step 1 and repeat for other brace
Insert end of the Table Brace into the pocket cut out in the Table End. Be sure the
groove track cut outs of the Table End face up as seen above. Place a Block G into
the Table End pocket cut out (recessed side out), insert a bolt through the block into
the threaded hole in the Table Brace, and finger tighten. Repeat this step for second
Table Brace.
3
ATTACH END SLATS
Step 3
Step 3
Fit a Table Top Slat End groove track cut outs with the assembled Braces and Ribs.
The threaded holes in the slats should line up with the pocket cut outs in the Braces
and Ribs. Place Block Gs into the Braces and Ribs pocket cut outs (recessed side
out), insert bolts through the blocks into the threaded holes in the Table Top Slat
End, and finger tighten. Repeat this step for second Table Top Slat End.
* It is very important that you finger tighten all bolts into inserts to ensure that you do not cross-thread bolts and inserts before tightening. It
will also be easier if you wait to tighten bolts until you have all bolts installed and the piece completely assembled. This will allow for more
movement of individual pieces and help in aligning holes with inserts. Use the Allen Tool provided to finish tighten bolt until snug.
Step 1 and repeat for other brace
Step 3
2
ATTACH RIBS
3 Slot Rib
3 Slot Rib
1 Slot Rib
3 Slot Rib
3 Slot Rib
3 Slot Rib
3 Slot Rib
1 Slot Rib
Step 2 and repeat step 1 on the other end
1 Slot Rib
Fit 1 Slot Ribs between the Table Braces by sliding them into the groove track cut
outs with the pocket cut out in the Rib facing the center of the table and with the
tabs facing up. Fit 3 Slot Ribs between the Table Braces by sliding them into the
groove track cut outs with the pocket cut out in the Rib facing the Ends of the table
and with the tabs facing up.
Repeat Step 1 to attach second Table End.
4
ATTACH MIDDLE SLAT
Step 2 and repeat step 1 on the other end
Step 2 and repeat step 1 on the other end
Step 3
Step 4 and repeat step 3 for other side
Step 4 and repeat step 3 for other side
Fit a Table Top Slat Middle groove track cut outs with the assembled Ribs. The
threaded holes in the slats should line up with the pocket cut outs in the Ribs. Place
Block Gs into the Ribs pocket cut outs (recessed side out), insert bolts through the
blocks into the threaded holes in the Table Top Slat Middle, and finger tighten.
*Using provided wrench securely tighten all previously finger tightened bolts.
1 Slot Rib
Step 4 and repeat step 3 for other side
3 Slot Rib
3 Slot Rib
1 Slot Rib
1 Slot Rib
Step 2 and repeat step
1 Slot Rib
S