RAK30 ROCK ADAPTOR KIT INSTALLATION INSTRUCTIONS
FOR THE GDI/CDI-30 SERIES USE THESE INSTRUCTIONS IN PLACE OF THOSE SUPPLIED WITH THE REK KIT.
REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE
LOG SUPPORT BRACKET
1. Remove all logs and media from appliance. If
necessary, refer to your installation instructions.
2. Remove the screw and log support bracket already
installed in the fi rebox.
4. Move rocks into position ensuring that the rocks are
sitting fl at on the burner.
6. Place the remaining refractory rocks around the
burner as desired, making sure not to cover any
burner ports. There are no set locations.
FOR USE WITH REK IN THE GDI/CDI-30 SERIES
!
WARNING
ROCK SUPPORT BRACKET
3. Secure the rock support bracket along the back of the
fi rebox.
NOTE : For best results, it is recommended
that you remove the grate and, using Wolf Steel
approved paint, paint the surfaces underneath
where the grate was removed.
5. Place the large rocks along the edge of the rock
support bracket, as shown.
W415-0849 / B / 11.09.16