Advertisement
7. On the right side of the equipment carrier,
find the:
•
Tele Aid microphone connector (A,
Figure 6) and connected jumper (B,
Figure 6) with black and white looped
wires
8. Disconnect the jumper (B, Figure 6) with
black and white looped wires from the Tele
Aid microphone connector (A, Figure 6) and
discard the jumper.
Note: Voice Control System (VCS) is not an
option, therefore neatly organize and wire tie
the VCS power supply and microphone array
cables along wiring harness of the equipment
carrier.
C. Mounting the MHI control module and antenna switch to the bracket
1. Mount the MHI control module to the
threaded studs on the bracket front with four
8 mm nuts (Figure 7).
Note: The MHI control module will mount to
the bracket threaded studs only one way (i.e.
there is no way to mount the MHI control
module to the bracket incorrectly).
2. Mount the antenna switch to the pre-tapped
screw holes in the bracket front—right of the
mounted MHI control module—with two
Phillips head machine screws (Figure 8).
4
PRELIMINARY DRAFT
Figure 6
Figure 7
Figure 8
November 2004
P82.70-xxxx-71
P82.70-xxxx-71
P82.70-xxxx-71
Advertisement
