Advertisement
Performing the Range Test of Your Personal Help Button Or Fall Detector Pendant.
Using the end of a pen Press and release the Test button located recessed on the
1.
bottom of the console. DO NOT hold down on the test button or this will clear the
buttons programmed into the console. The console will announce "Test
mode....firmware version number and hardware version number. The Cancel
button flashes Orange.
Now press the button to begin the test. The console will announce "emergency,
2.
zone 1 or 2 (if two buttons are programmed) fall signal (fall signal is announced for
both the standard button and fall detector).
Note: Test mode will automatically exit after 3 minutes of inactivity.
When range test is finished, press the CANCEL to exit test mode. Unit announces
3.
"Console Ready".
Now press your Personal help button or fall detector pendant. A
on the button. The console will beep and announce "emergency call being placed. Help
button on console flashes Red, console announces "Emergency reported & voice call
being placed".
You will know the Connect Care equipment has tested successfully when the call is
answered by the monitoring Centre. Advise them you are testing. The operator will reset
the console and the Help button will go solid Green.
Repeat this step with each button if there are two or more buttons programmed to the
console.
From
Connect Care
Medical Alert Service
green light
will appear
4.
Advertisement
