Frontgate 62333 Manual

ITEM DESCRIPTION: NICKEL & MARBLE ENTERTAINING ÉTAGÈRE
NOTE-In C section washer (A) is for over and under each of the glass shelves and
(B) and (C) are used for the marble base to tighten the base of legs to the marble.
 STEP 1: Place all pieces out on a clean work surface. Please ensure all of the
above pieces are included in your package.

STEP 2: Place the marble base on a stable surface. Make sure all four round metal
balls are securely attached to the bottom side of the marble base. The ball feet are
already attached and no additional assembly is needed.
PLEASE NOTE: The legs of the étagère are comprised of 3 pieces: base, center
AND top portion with finial (AS SHOWN IN IMAGE SECTION "D").
 STEP 3: Take bottom section of the legs PART A/ SECTION D and place on the top
side of the marble base. Then on the underside of the marble tighten the base to
marble with the help of washer (b) and nut (c). Place washer on first and then the
nut and then tighten. Do this for each leg.
 STEP 4: After fitting the bottom section of the legs place the first glass (B) through
the holes by using rubber washer (A) on both sides of the glass.
Item # 62333
1 | P a g e