PowerPoint TW18-2 Instruction Manual page 13

- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter. you can remove the filter system. Remove any food remnants and clean the
filters under running water.
1
2
3
NOTE：
If do it from step1 to step 3, the filter system will be removed; while if do it from step3 to step 1, the filter system
will be installed.
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
1
Cut off electrical power to the dishwasher.
2
Turn off the water supply and disconnect the water
inlet pipe from the water valve.
3
Drain water from the inlet
(Use a pan to catch the water.)
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings.
pipe and water valve.
step１：Turn the filter in anti-clockwise direction,
then lift it up
step２：lift the Main filter up
step 3： lift the Fine filter up
4
Reconnect the water inlet
water valve.
5
Remove the filter in the tub the bottom
and use a sponge to soak up water
in sump.
Remove the upper spray arm
To remove the upper spray arm, screw off the nut clockwise then remove
the arm.
Remove the lower spray arm
To remove the lower spray arm, pull out
Wash the arms
Wash the arms in soapy and warm water and use a soft brush to clean
the jets. Replace them after rinsing them thoroughly.
10
pipe to the
the spray arm upward .