Fisher & Paykel GD75IA1 Troubleshooting page 2

Problem Possible causes
grinding ring.
Improper seating
of the sink flange.
Unit is
leaking at
Improperly
the top installed rubber
gasket.
connections
Mount ring not
tightened properly
Unit is
leaking at
Discharge outlet
the
elbow may not be
tightened.
discharge
outlet.
Water is
Rubber splash
slow to
guard fingers
drain from trapping air inside
the chamber.
the sink
https://producthelp.fisherpaykel.com/nz/Clean/Dishwashing_Accessories/GD75IA1/User_Guide_GD75IA1/05_Troubleshooting
Check that the sink flange is centred and sealed tightly into the sink drain by
the mounting assembly from underneath. Refer to step 2 of the
Instructions'.
Check that the rubber gasket is sitting flat under the lip of the sink flange.
Refer to step 2 of the 'Installation
Discharge outlet elbow may not be tightened. Check the discharge elbow is
tight. Refer to step 13 of the
Check the discharge elbow is tight. Refer to step 13 of the
Instructions'.
When the rubber splash guard is new, air can become trapped within the
chamber preventing water from draining quickly. Pushing food through the
rubber splash guard will release the air and the water will drain. Over time,
the splash guard fingers will soften and flex, holding back less air and aiding
drainage.
What to do
Instructions'.
'Installation Instructions'.
Updated: Fri, 28 Feb 2020 09:47:46 GMT
'Installation
'Installation
Powered by
2