Functional Description - Makita BO5030 Instruction Manual

FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► 1. Switch
CAUTION:
• Before plugging in the tool, always be sure that
the tool is switched off.
To start the tool, press the "I (ON)" side of the switch. To
stop, press the "O (OFF)" side of the switch.
Speed adjusting dial
For BO5031 only
► 1. Speed adjusting dial
The tool speed can be infinitely adjusted between 4,000
and 12,000 orbit per minute by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 5; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the figure for the relationship between the num-
ber settings on the adjusting dial and the kind of work.
A range: For polishing
B range: For finish sanding
C range: For regular sanding
12,000
4,000
NOTE:
• The figure shows standard applications. They
may differ under certain conditions.
1
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive disc
To install the abrasive disc, first remove all dirt or for-
1
eign matter from the pad. Then peel off the backing
paper from the abrasive disc and attach the abrasive
disc to the pad. Be careful to align the holes in the
abrasive disc with those in the pad.
CAUTION:
• If you peel off the abrasive disc from the pad,
its adhesion will become poor. Never attempt to
stick it onto the pad for further use.
4 ENGLISH
B
A
1 2 3
Dial setting
C
4 5