Installation Considerations - ACEK9 H-RBM Install Manual

 The Pager transmits radio signals and should be mounted at least
6 inches from other electronic devices.
 Mount in a dry location.
Step 1 Install Pager Antenna, Follow instructions included with antenna.
Step 2 Plug Antenna into the Pager Transmitter socket marked "ANTENNA".
Socket marked radio is not used.
Step 3 Set antenna switch to "B" for external mounted mast style antennas.
Step 4 Unplug the 24 Pin Connector from the Protective Relay Module (PRM).
Insert Gray Pager terminal wire into Pin 4 location.
Insert Black Pager terminal wire into Pin 3 location.
Insert Red/Gray Pager terminal wire into Pin 15 location.
Step 4 Attach the Pager Transmitter's Black wire to PRM's Black terminal
wire.
Step 5 Connect the Pager's Red power wire to PRM's Red/Gray terminal
wire.
Step 6 Connect the Pager's Blue wire to the PRM's Gray wire.
Step 7 Install 2 AAA batteries and program receiver
Step 8 The Pager Receiver comes programmed to match the receiver. If an
additional receiver needs programming follow the following steps in the back of
this manual.
Step 9 Test the Pager System with the Heat Alarm. Run a system Test to verify
transmission (See manual of your AceK9.Com product)
Step 10 Secure the Pager Transmitter in a dry location.
Pager Install Manual
Systems with protective relay module

Installation Considerations

H-RBM
.
2