Advertisement
ECRESO FM 750 W/1000 W/1500 W/2000 W, user manual– 12/2017
D.5. Replacing an audio board
This procedure must be used to replace a defective audio board or to replace the analog audio board by an AES board.
!
Software version 1.4 or more is required to replace the analog audio board by an AES board.
In the standard configuration, the transmitter is fitted with:
One analog audio board (Line 1)
·
One AES board (Line 2)
·
1. Turn off the module and unplug it from the mains.
2. Unscrew all lid screws and remove the lid.
3. On the rear panel, remove screws for the board that needs to be replaced: 4 screws for the analog audio
board, 2 screws for the AES board:
Analog audio board
Head Office : Parc d'activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
AES board
www.worldcastsystems.com – contact@worldcastsystems.com
Page 202
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Worldcast Systems ECRESO FM 750 W
Summary of Contents for Worldcast Systems ECRESO FM 750 W
- Page 1 ECRESO FM 750 W/1000 W/1500 W/2000 W, user manual– 12/2017 D.5. Replacing an audio board This procedure must be used to replace a defective audio board or to replace the analog audio board by an AES board. Software version 1.4 or more is required to replace the analog audio board by an AES board.
- Page 2 ECRESO FM 750 W/1000 W/1500 W/2000 W, user manual– 12/2017 4. Inside, disconnect the board by pulling lightly and take it out. Analog audio board AES board 5. Place the new audio board by first putting the BNC connectors through the rear panel cutouts, and then connect it to the commutation board.
Need help?
Do you have a question about the ECRESO FM 750 W and is the answer not in the manual?
Questions and answers