Moen Darcy Y1518 Series Installation Instructions

™
Darcy Technical Specification
18 in. & 24 in. Towel Bar
Stock Numbers:
Y1518CH – 18" Towel Bar

Chrome Finish
Y1518BN – 18" Towel Bar

Brushed Nickel Finish
Y1524CH – 24" Towel Bar

Chrome Finish
Y1524BN – 24" Towel Bar

Brushed Nickel Finish
Materials:
Towel Bar is constructed of zinc.
Dimensions:
Installation Instructions:
Tools Required: Phillips screwdriver, drill, 1/4" drill bit, hammer, level, tape
Hardware Kit Contents: 2 anchors, 1 hex wrench
Note: Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.
1) Remove mounting posts from the product assemblies by loosening each
setscrew.
2) Position the mounting plate on the wall in the desired location and mark
holes at the Horizontal screw location on the template if installing into
drywall or vertical screw location if installing into a stud.
3) Drill 1/4" pilot holes in marked locations.
4) Lightly tap anchors until flush with the wall.
5) Place each mounting plate over anchors and insert screws through post
into anchors.
6) Tighten screws.
7) Place posts over the mounting plates with setscrew facing down and
tighten setscrew.
Cleaning Instructions:
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Stock Number: ______________ Towel Bar
2 5 3 0 0 A L M O E N D R I V E  N O R T H O L M S T E D , O H 4 4 0 7 0
C O R P O R A T E H E A D Q U A R T E R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9  F A X : ( 8 0 0 ) 8 4 8 - 6 6 3 6
I N T E R N A T I O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0  F A X : ( 4 4 0 ) 9 6 2 - 2 7 2 6
C U S T O M E R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6  F A X : ( 8 8 8 ) 3 7 9 - 2 7 2 0
W W W . M O E N . C O M
© 2015 Moen Incorporated. Moen is a registered trademark and Darcy is a trademark of
Moen Incorporated. All rights reserved.
Y1518 & Y1524