Advertisement
This package contains small parts
in its unassembled state.
Adult assembly is required.
1
• Turn over both bases on a flat surface.
• Fit the base connector onto the bases.
Hint: The base connector is designed to fit on the bases one way.
If it does not seem to fit, turn it around and try again!
2
• Insert four screws into the base connector and tighten.
• Turn the assembly upright.
CAUTION
Base Connector
Bases
Assembly
Wall with
Radio
B
3
• Position the gate so that the notched edge is up.
• Fit the peg on the bottom of the gate into the hole in the base
assembly
.
A
• While holding the gate in place, fit the wall with radio into the base
assembly
B
.
4
Gate Notched Edge
Bottom Peg
A
Advertisement
