Page 2
IMPORTANT! READ CAREFULLY BEFORE USE. KEEP THIS GUIDE FOR FUTURE REFERENCE. This guide shows how to install the power module in the Switch. Graphics in this book may differ slightly from your product. Every effort has been made to ensure that the information in this manual is accurate.
H A PT ER Power Module Installation 1.1 Overview Although all modules are hot-swappable, it is recommended you disconnect power or make sure you are safely grounded and dry before installing or removing power modules. There is one power module installed in the first power slot of the Switch by default. This section shows you how to install a second power module or remove the power module.
Page 4
Chapter 1 Power Module Installation Insert the power module into the slot. Slide the power module into the slot until it makes contact with the backplane and tighten the screws. Power Module Hardware Installation Guide...
Chapter 1 Power Module Installation 1.1.2 Removing a Power Module Use the following procedure to remove a power module from the Switch. Disconnect the power before you begin. Use a screwdriver to loosen the screws on the front panel of the power module. Grab the handle and slide the power module out.
Page 6
Chapter 1 Power Module Installation Power Module Hardware Installation Guide...