Daily Use - Brandt BFU4425SW Instructions For Use Manual

Hide thumbs Also See for BFU4425SW:
Table of Contents

Advertisement

Available languages

Available languages

DAILY USE

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap
so as to remove the typical smell of a brand
new product, and then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
Turn on
Plug in the appliance, LED lighting.
XXX
star class
Mode
• When firstly push "MODE" button, the lamp
"SUPER" is lighted on, and the appliance would
be fast freezing and the LED displays "SF"
(super freezing).
• When secondly push "MODE" button, the
fasting freezing lamp black out, and the "ECO"
lamp is lighted on, the appliance would go into
"ECO" mode, the appliance will run with the
setting at -16° and the LED will display "SE"
(save energy).
• When you thirdly push "MODE" button, both
of lamps of "SUPER" and "ECO" black out, the
appliance would be back to setting mode by
user.
Temperature Setting
Push "TEMP" button, the LED number would
be
glistening,
temperature by pushing "TEMP" button. The
setting is cycling to change from -16 to -22°C.
After 5 seconds, the setting temperature is
confirmed.
Lock
When push "MODE" and "TEMP" buttons at
the same time for 3 seconds, buttons will be
locked and the lamp lighted on. If you want to
unlock the buttons, push "MODE" and "SETTING"
at the same time 3 seconds again.
Turn off
Push and hold "TEMP" button for 5 seconds
and switch off the appliance. To switch on,
push and hold "TEMP" button for 5 seconds
again.
Displayed Temperature
Important! LED always displays the setting
temperature, not real temperature.
Door open alarm
If miss to close door for five minutes, the door
open alarm will give out alarm sound which
will be three times each 5 seconds and last 5
minutes and then stop 5 minutes and again
give out alarm sound till you close door
High temperature alarm
After
running
for
temperature is more than -8 , the LED will
alternately display "ht" and real temperature
("ht" means high temperature) and give out
alarm sound with frequency of 1Hz, till you
push any button to stop.
25
you
could
adjust
3
hours
and
if
the
the

Advertisement

Table of Contents
loading

Table of Contents