Installation - Brandt BFU4425SW Instructions For Use Manual

INSTALLATION

Install door external handle
Rear spacer
Screw the rear spacers at the rear of the
appliance
Space Requirement
• Keep enough space of door open.
• Keep at least 50mm gap at two sides
Levelling the unit
To do this adjusts the two levelling feet at
front of the unit.
If the unit is not level, the doors and magnetic
seal alignments will not be covered properly.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Location
The appliance should be installed away from
sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To
ensure best performance, if the appliance is
positioned below an overhanging wall unit, the
minimum distance between the top of the
cabinet and the wall unit must be at least 100
mm. Ideally, however, the appliance should
not be positioned below overhanging wall
units. Accurate levelling is ensured by one or
more adjust-able feet at the base of the
cabinet.
Warning! It must be possible to disconnect
the appliance from the mains power supply;
the plug must therefore be easily accessible
after installation.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance
Directives.
24
complies with the E.E.C.