Harley Benton GA-260H DSP Important Safety Instructions

GA-260H DSP
IMPORTANT SAFETY INSTRUCTIONS
Please read before using this product and strictly follow the owner's manual
Please keep this manual for future reference.
1. Connect the amplifier ONLY to a properly grounded AC outlet of the proper voltage for your amp.
2. Avoid the thread to be under kick or heavily hustled.
3. Do not block any ventilation openings on this amplifier.
4. Do not operate near any heat source.
5. Do not expose this amplifier to rain or moisture.
6. Disconnect the power cord if the amplifier is not in use for longer period.
7. To reduce the risk of electric shock, DO NOT remove the cover.
CAUTION
Voltage: AC 220V~50Hz
To reduce the risk of fire or electric shock. Do not expose this apparatus to rain or moisture. To reduce the
risk of electric shock. Do not remove cover. Refer servicing to qualified service personnel for repair this
apparatus.
The exclamation point within an equilateral triangle is intended to alert you to the presence of
important operating and servicing instructions.
The lighting flash & arrowhead symbol, within an equilateral triangle, is intended to alert you to the
presence of danger.
ATTENTION
To avoid to damage amplifier or other equipments, please turn off the level of all equipments before
connection and power off the equipments as well.
Power on the equipments ordinal.
This amplifier equips with protected circuit, which will startup for few seconds after the amplifier powers on.
This amplifier will be MANUAL mode state as it powers on.
PANEL DESCRIPTIONS
1 4
1. Input jack 1/4"(6.35mm): Use this jack to connect electric guitar
2. Set/Manual button: Use this button to store the setting in Channel 1 to 5.
More details of usage please see User setting
3. Channel 1to 5: Use these channels to stored user setting
4. Amp Models: Use this control to select 4 models of( each model has two tone) Clean, Tweed, Fuzz, Metal.
5. Gain: Use this control to adjust the level of gain
6. Level: Use this control to adjust the output level
7. EQ: Use these 3 controls to adjust Bass Mid and Treble frequency level, ( 12dB)
8. Modulation: Use this control to select modulation effects: chorus flanger phase wah-wah
9. TAP: Use this control to set the rate of effect
10. DELAY: Use this control to adjust the feedback and output level of delay. )
11. TAP: Use this control to adjust the time of delay
12. REVERB: Use this control to adjust the output level of reverb.
AMPLIFIER HEAD
RISK OF ELECTRIC SHOCK
2 3
5 6
C A U T I O N
DO NOT OPEN
7 8
9 11
10
12
o
13 15
14