Huawei H112 Quick Start Manual page 7

FAQs
How do I restore factory settings?
When the router is turned on, press the Reset
button for approximately 3 seconds using a pointed
object until the Ambient light strip starts to blink.
Restoring factory settings will restore the settings
to the default. You can reconfigure them after the
router is restored.
What should I do if I forgot the Wi-Fi password or
the login password for the web-based management
page?
Restore the router to its factory settings and then
use the default Wi-Fi password and login password
to try again.
What should I do if the 5G signal indicator and 4G
signal indicator are off or an Internet connection
cannot be established?
1. Check if the SIM card is inserted. Refer to the
Setup section for the right size of SIM card and
the right way to insert it into the slot.
2. If the issue persists, restore the router to factory
settings and try again.
3. Contact your carrier to check if your SIM card
is out of service. If it's a new card, check if it has
been activated.
What should I do if the Internet speed is slow?
1. Check the 5G signal indicator and 4G signal
indicator on the router. If both of them are red,
adjust the router's direction or move it close to a
window to improve signal reception.
2. If your device is connected to the router over
Wi-Fi, adjust your device's position to receive
better signal.
3. Switch to Wi-Fi 5 GHz if it is supported by your
device.
4. Restart the router and your device, and try again.
5. Check if you have reached your data traffic limit
for the month. If so, your carrier may limit your
Internet speed.
How can I connect to the router using WPS (Wi-Fi
Protected Setup)?
To connect a WPS-enabled device to your router
using the Hi/WPS button:
1. Press and hold the Hi/WPS button on the router
for at least 1 second and then release, the Wi-Fi
indicator starts to blink.
2. Enable WPS on your device within 2 minutes to
connect to the router's Wi-Fi network.
Why can't I access the router's web-based
management page?
1. Ensure that your computer is connected to the
router through an Ethernet cable or Wi-Fi.
2. Ensure that your computer is set to obtain an IP
address and DNS server address automatically.
3. Restart your browser, or try using another browser.
4. If the problem persists, restore the router to its
factory settings.
Why is the content displayed on the web-based
management page not up to date?
Depending on your browser's cache, the content for
your device on the web-based management page