Land Pride 380-168A Installation Instructions Manual

Third Function Valve Kit
380-168A & #380-335A Installation Instructions
#
For B3350 & B2650 Kubota Tractors with LA534 & LA534A Loaders
Before You Start
When you see this symbol, the subsequent
!
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
California Proposition 65
WARNING: Cancer and reproductive harm.
!
www.P65Warnings.ca.gov
IMPORTANT: Before you begin, thoroughly read
these instructions and check to be sure all parts are
accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
General Information
Your Third Function Valve Kit has been designed
specifically for the Kubota B3350 and B2650 tractor
series equipped with a Kubota LA534 and LA534A front
loader. These assembly instructions apply to the Third
Function Valve Kit Accessories listed below:
• 380-168A: 3FVK PC B3350 . . . . . . . . . . . . . . . page 2
• 380-335A: 3FVK FF B3350. . . . . . . . . . . . . . . . page 2
Further Assistance
Your Land Pride dealer wants you to be satisfied with your
new Third Function Valve Kit. If for any reason you do not
understand any part of this manual or are not satisfied
with the service received, the following actions are
suggested:
1. Discuss any problems you have with your Third
Function Valve Kit with your dealership service
personnel so they can address the problem.
2. If you are still not satisfied, seek out the owner or
general manager of the dealership, explain the
question/problem, and request assistance.
3. For further assistance write to:
Land Pride Service Department
1525 East North Street
P.O. Box 5060
Salina, Ks. 67402-5060
E-mail address
lpservicedept@landpride.com
© Copyright 2019 Printed 11/22/19
Assembly Instructions
A detailed listing of parts for your cab tractor's 3rd
Function Valve Kit is provided on page 6 for kits using
pioneer couplers, and page 8 for kits using flat faced
couplers. Use the list that is for your specific Third
Function Valve Kit as a checklist to inventory parts
received. Please contact your local Land Pride dealer for
any missing hardware.
Direction Reference
All directional references are made from the operator
seat while facing the direction the machine will operate.
Initial Preparations
!
To avoid serious injury or death: Hydraulic fluid under high
pressure can penetrate the skin and/or eyes causing a serious
injury. Wear protective gloves and safety glasses or goggles
when working with hydraulic systems.
The steps listed below must be followed before installing
this kit:
1. If attached, dismount loader from tractor. If loader is
not attached, skip to step 4.
2. Turn tractor off, then relieve all hydraulic pressure
from hydraulic lines by operating the loader control
lever in all directions. Proceed with locking the control
lever.
3. Disconnect loader hydraulic lines.
4. Restart tractor and slowly back away from loader.
5. Park tractor on a flat, level surface. Put tractor in park
or set park brake, turn off engine, and remove switch
key to prevent unauthorized starting.
6. As a safety precaution, disconnect the negative
battery cable from battery terminal. Move cable away
from terminal to avoid accidental contact.

Manual No. 380-169M
U
F
L
U = up
L = left
B
R
D
B = back
Directional Arrows Used in Illustrations
WARNING
KEY:
D = down
R = right
F = front
1