Advertisement
Quick Links
For service information call 800-544-3057
Please have the following information available before calling. Information can be found
on the identification/certification tag:
•Model Number
•Serial Number
•Date of Purchase
•Part Description and number as shown in parts list
This manual contains important safety information concerning the maintenance, use and operation of this product.
Failure to follow these instructions could result in damaging equipment, voiding the warranty, serious injury or even death.
NCO-2H COUNTERTOP OVEN
Installation and Operating Manual
IMPORTANT INFORMATION
READ BEFORE USE
Piper Products, Inc
300 South 84th Avenue
Wausau, WI 54401
Phone: 715-842-2724 . FAX: 715-842-3125
Advertisement
Related Manuals for Piper NCO-2H
Summary of Contents for Piper NCO-2H
- Page 1 NCO-2H COUNTERTOP OVEN Installation and Operating Manual For service information call 800-544-3057 Please have the following information available before calling. Information can be found on the identification/certification tag: •Model Number •Serial Number •Date of Purchase •Part Description and number as shown in parts list...
-
Page 3: Table Of Contents
TABLE OF CONTENTS INTRODUCTION FREIGHT DAMAGE CLAIMS UNPACKING, SETUP , AND SPECIFICATIONS OVEN OPERATION GENERAL CLEANING AND MAINTENANCE TROUBLESHOOTING GUIDE NCO-2H PARTS BREAKDOWN WIRING DIAGRAM WARRANTY... -
Page 4: Introduction
Congratulations! You have just purchased one of the finest pieces of equipment on the market today. Before installing or operating your new Piper equipment, you should read through this manual. This manual should be retained for further reference as it contains installation and operating instructions, service tips, part lists and warranty information. -
Page 5: Unpacking, Setup And Specifications
Assembly The NCO-2H oven comes completely assembled with the exception of the two wire bake racks. Place one wire rack over each set of elements in the oven. The bent side of the rack should be toward the front of the oven pointing down. -
Page 6: Oven Operation
375°. Allow 15 to 30 minutes for the oven to pre-heat. Set the reminder timer for the appropriate setting. The buzzer will sound when time has elapsed. Turn the knob to the left to silence the buzzer. The chart below illustrates the baking production ability of the NCO-2H. ITEMS QTY. -
Page 7: General Cleaning And Maintenance
Door hinges and magnet can be adjusted so the door and gasket are allowed to seal properly. Steel Surfaces: • Piper only approves soap and water for cleaning stainless steel. • NOTICE: Do NOT use chlorinated cleaners. -
Page 8: Troubleshooting Guide
Indicator light should come on when Thermostat thermostat is turned up. Faulty element Check for internal element ground. Excessive deck heat Indicator light should go off when thermostat Thermostat is turned off. Call Piper Products directly at 800-544-3057 if you need further assistance. -
Page 9: Nco-2H Parts Breakdown
NCO-2H PARTS BREAKDOWN Repair parts can be ordered by calling Piper at 800-544-3057. When ordering replacement parts include the model number, serial number, and replacement part number. ITEM NO. PART NUMBER DESCRIPTION 704768 120V/1500W Element 305206 Gasket (sold per foot) -
Page 10: Wiring Diagram
NCO-2H WIRE DIAGRAM NEMA 5-20 180 watts 180 watts 180 watts light rocker switch 180 watts 180 watts T-Stat 180 watts 180 watts 180 watts 180 watts 180 watts timer Buzzer WIRING DIAGRAM 300 South 84th Ave. - Page 11 Piper Products Service Department shall be final. Any defective parts to be repaired or replaced must be returned to Piper Products, Inc., 300 South 84th Avenue, Wausau, WI 54401, transportation charges prepaid, and they must be properly packed and tagged.
- Page 12 Piper Products, Inc 300 South 84th Avenue Wausau, WI 54401 Phone: 715-842-2724 . FAX: 715-842-3125...
Need help?
Do you have a question about the NCO-2H and is the answer not in the manual?
Questions and answers