WARNING! Before carrying out any operations with the unit, carefully read this instruction manual and keep it with cure for future reference. It contains important about the installation, usage and maintenance of the unit. SAFETY eneral nstrUctIon • The products referred to in this manual conform to the European Community Directives and are there-fore marked with CE:.
Page 6
• Make sure that the device is not exposed to extreme heat or dust. • Make sure that the available voltage is not higher than stated on the rear panel. • Make sure that the power cord is never crimped or damaged. Check the device and the power cord from time to time.
SPECTROMETRY Distance 5 meters Color Wave Length 639 nm 6291 lux Green 534 nm 49027 lux Blue 448 nm 2864 lux RGB LEDs 60000 lux MK305s easureMents Made with u pectruM RED LED GREEN LED Page 7...
dmX connectIon The projectors are connected in series to a DMX console. Connect the projectors as shown in the diagram above. - Connect the male side of the DMX cable to the output of the DMX512 console. - Then connect the DMX output of the projector to the input of the next projector. - Repeat the operation on the whole chain.
MENU THE VALUES IN ARE DEFINED BY DEFAULT IN THE MENU AND RELOADED AS IN THE CASE OF «RELOAD DEFAULT SETTINGS» Menu Sous-Menu Options Receive A001~AXXX Set Address Standard (22 C) - (16bit) Basic (19 C) - (8bit) Extend (25 C) - (16bit) User Mode User A User Mode...
Page 12
Clear Last Clear Total R: XXXF Temp. Info G: XXXF B: XXXF Information Fan1 : xxxxRPM Fan Speed Fan2 : xxxxRPM Error. Info NONE/Pan,Tilt….. Model. Info Aperta 1U01 V1.0.2 2U01 V1.0.2 Software.V 3U01 V1.0.2 4U01 V1.0.2 5U01 V1.0.2 Page 12...
Page 13
Configuration of the Aperta DMX address USER MODE MENU ser Mode: Selection of the DMX mode of the Aperta between the different modes such as: - Basic 19 DMX channels - 8-bit mode - Standard 22 DMX channels - 16-bit mode...
Page 14
Move Speed: Selection of movement speed between 1 and 4 1 - faster to 4 - slower Hibernation: OFF - 01 Min to 99 Min - Selection of hibernation mode the Aperta. OFF by default or from 1 minute to 99 minutes before switching to hibernation mode. Fixture ID Sub-menu allowing the modification of the DMX universe of reception (ArtNet and sACN) as well as the IP address and the subnet mask of the Aperta.
QuickPath Sub-menu allowing the activation or deactivation of the QuickPath function to define the behavior of the Aperta when switching from a continuous rotation movement to a «standard» movement. This mode remains activated via the Control channel (19, 22 or 25 depending on the DMX mode chosen);...
Page 16
Flip Display - ON / OFF - Reversal of the display direction KeyLock - ON / OFF - Locking of the Aperta buttons. DispFlash - ON / OFF - Activation or not of the display flash when the Aperta does not receive a DMX signal.
Page 17
Fine, Focus , Frost, DimMode, P / T Speed, Reset / Prog Calibrate: Sub-menu allowing to recalibrate the engines and the LEDs of the Aperta to access this menu, enter the PIN code for unlocking this function. Pin Code: 060...
DMX MAP Basic Mode Channel Value Description 000-255 PAN 8bit 000-255 TILT 8bit PAN CONTINUOUS ROTATION 000-127 Idle 128-189 Pan clockwise from fast to slow 190-193 STOP 194-255 Pan counter-clockwise from slow to fast TILT CONTINUOUS ROTATION 000-127 Idle 128-189 Tilt clockwise from fast to slow 190-193 STOP...
Page 21
PRISM1 000-031 Open 032-255 8 facet prism PRISM1 ROTATION 000-127 Prism 1 indexing 0° To 360° 128-189 Clockwise rotation from fast to slow 190-193 STOP 194-255 Counter clockwise rotation from slow to fast PRISM2 000-031 Open 032-255 6 facet linear prism PRISM2 ROTATION 000-127 Prism2 indexing 0°...
Page 22
DIM MODES 000-020 DIM 0 021-040 DIM 1 041-060 DIM 2 061-080 DIM 3 081-100 DIM 4 101-255 Default to Unit Setting SPEED PAN/TILT MOVEMENT 000-225 max to min speed 226-235 blackout by movement 236-255 Idle CONTROL 000-019 Idle 020-029 Fan Speed Set Auto 030-039 Fan Speed Set High...
Page 23
Standard Mode Channel Value Description PAN 8bit 000-255 PAN FINE 16bit 000-255 TILT 8bit 000-255 TILT FINE 16bit 000-255 PAN CONTINUOUS ROTATION 000-127 Idle 128-189 Pan clockwise from fast to slow 190-193 STOP 194-255 Pan counter-clockwise from slow to fast TILT CONTINUOUS ROTATION 000-127 Idle...
Page 25
PRISM1 000-031 Open 032-255 8 facet prism PRISM1 ROTATION 000-127 Prism 1 indexing 0° To 360° 128-189 Clockwise rotation from fast to slow 190-193 STOP 194-255 Counter clockwise rotation from slow to fast PRISM2 000-031 Open 032-255 6 facet linear prism PRISM2 ROTATION 000-127 Prism2 indexing 0°...
Page 26
DIM MODES 000-020 DIM 0 021-040 DIM 1 041-060 DIM 2 061-080 DIM 3 081-100 DIM 4 101-255 Default to Unit Setting SPEED PAN/TILT MOVEMENT 000-225 max to min speed 226-235 blackout by movement 236-255 Idle CONTROL 000-019 Idle 020-029 Fan Speed Set Auto 030-039 Fan Speed Set High...
Page 27
Mode Extended Channel Value Description 000-255 PAN 8bit 000-255 PAN FINE 16bit 000-255 TILT 8bit 000-255 TILT FINE 16bit PAN CONTINUOUS ROTATION 000-127 Idle 128-189 Pan clockwise from fast to slow 190-193 STOP 194-255 Pan counter-clockwise from slow to fast TILT CONTINUOUS ROTATION 000-127 Idle...
Page 29
PRISM1 000-031 Open 032-255 8 facet prism PRISM1 ROTATION 000-127 Prism 1 indexing 0° To 360° 128-189 Clockwise rotation from fast to slow 190-193 STOP 194-255 Counter clockwise rotation from slow to fast PRISM2 000-031 Open 032-255 6 facet linear prism PRISM2 ROTATION 000-127 Prism2 indexing 0°...
Page 30
DIM MODES 000-020 DIM 0 021-040 DIM 1 041-060 DIM 2 061-080 DIM 3 081-100 DIM 4 101-255 Default to Unit Setting SPEED PAN/TILT MOVEMENT 000-225 max to min speed 226-235 blackout by movement 236-255 Idle CONTROL 000-019 Idle 020-029 Fan Speed Set Auto 030-039 Fan Speed Set High...
Page 31
STARWAY Paris Nord 2 78 Allée des Érables 93420 Villepinte France Tél. : +33 (0)820 230 007...
Need help?
Do you have a question about the Aperta and is the answer not in the manual?
Questions and answers