Advertisement
• Fill the tank with cold water. There is a MAX line marked inside of the tank. Do not fill water over this mark.
• Replace the cover and switch the unit on. The heating lamp indicator should now light up and the unit will begin
to heat the water.
• After about 35 minutes, the water temperature will have reached 97 degrees and the auto-thermostat will take
over, automatically keeping the water at the correct temperature selected.
The appliance is fitted with a dry-protect thermal cut-out. If this is activated, the unit will turn itself off. This protects
the heating elements and inner facility. The unit must be unplugged before it can be reset. To reset the appliance,
wait until the unit has been cooled down. Then press the reset button at the bottom of the appliance. The
appliance can then work normally.
This safety device may have been triggered during transport; if so, reset the thermal cut-off following the
above instructions.
If resetting this thermal cut-out does not switch the unit back on, please contact your nearest branch or call the
tech team on 0800 504 504
This unit must be cleaned thoroughly after each use. This is in addition to weekly cleaning using vinegar to
remove mineral deposits. If these deposits are not removed, pitting of the metal can occur and may result in
damage to the appliance. Do not hose unit.
1. Be sure to unplug the unit, discard any remaining water and allow to cool down before cleaning.
2. DISCOLORING OF THE WATER TANK
This is caused by oxidizing of iron content in tap water. It can be removed by using nylon brush and
following these simple steps:
• Cut a lemon into four, wrap the lemon in cloth and place inside the unit.
• Pour water up to the full water level indicator.
• Boil the water and let the mixture remain inside the unit for about 1 hour.
• Pour the water out and use a nylon brush to clean the inner part.
• To remove the smell of the lemon, boil water again, and dispose the water.
3. Lid and tank are washable with soap and water.
4. Use damp cloth to clean the body. Wipe it dry. Do not use abrasive materials to avoid scratches.
USING THE URN:
RESET THERMAL CUT-OUT
CLEANING THE APPLIANCE
CLEANING AFTER USE:
3.
Advertisement
